PRT CTRL Integrated Controller Reference Manual

UN00001 Misc
[1-34----]
To modify options, use the follow the settings as explained in section Entering Data Options
on Page 409.Use the relevant key from 1 to 8 to toggle the state of the option.
Option 1 - Greeting Mode
Enabled the user will be presented on the keypad screen with a time of day
greeting when they log in to the keypad. For example "Good Morning Mr.
Smith" or "Good Afternoon Mr. Jones".
Disabled the user will not be shown a greeting when they log in to the
keypad.
This option when enabled can be overridden by the same option in the
menu group. To control this option per individual user disable the
option in the menu group and assign this option for each user that
requires a greeting message displayed on login.
Option 2 - Menu Mode
Enabled the user will be taken directly to the menu. Normally a user will be
shown the status of the current area that the keypad belongs to however
this feature allows users that can not perform any area commands or that
are more likely to perform menu commands to be taken directly to the
menu without pressing the [MENU] key when they log in.
Disabled the user will be taken to the primary area status screen if they
have access to the programmed area.
Option 3 - Alarm Acknowledgement Allowed
Enabled the user can acknowledge and delete alarms that are stored in
memory for an area by using the [ENTER] key. To acknowledge alarms, the
user must have access to the View menu. The area where the alarm
occurred must also belong to the user’s disarm area group.
Disabled the user will not be able to acknowledge alarms.
This option when enabled can be overridden by the same option in the
menu group. To control this option per individual user disable the
option in the menu group and assign this option for each user.
Option 4 - Show Alarm Memory On Login
Enabled the user when logging in to the keypad will be displayed any
existing alarm for the keypad’s primary area. If an alarm occurred in any
other area, the alarm memory is sent to the alarm buffer, which can be
viewed through the View menu. To view the alarm memory, the user must
be allowed to access the View menu. The keypad’s primary area must also
belong to the user’s disarm area group. If you want to acknowledge the
alarm, the Alarm Acknowledgement option must be turned on.
Disabled the keypad will take no action if alarm memory is present when a
user logs in.
Protégé Integrated System Controller Reference Manual
46