PRT CTRL Integrated Controller Reference Manual

Use the numerical keys to enter a valid time in a 24HR format and then press [ENTER] to
program the time. If you do not program a time in the following section the user will expire at
midnight on the date that is programmed. For more information about entering the date
information refer to the section Date and Time Data Entry on Page 407.
If you do not enter a valid time an error message will be shown, pressing the [STAY] key will
allow you to clear your entry.
User Family / Facility Number
When a user requires control of card readers and access functions in the Protégé System they
must be programmed with a facility code or family number and a card number. The first
screen shown will be the family number of the access control card that will be given to the
user, enter the family number of the card and then press [ENTER].
UN00001 Facility
id: 4294967295
The family number is not normally printed on the card or tag. This is typically provided on a
reference document provided with the cards at the time they are purchased. If you are not
sure of the facility code or card number you can present the card to any reader that is
programmed in the system. The facility or family id number that is read will be displayed in
the screen only if it is not already programmed or allocated to a user.
The number 4294967295 is the maximum facility code and is a reserved number,
setting this number will disable the card for this user.
User Card Number
When user requires control of card reader and access functions in the Protégé System they
must be programmed with a card number. Type the family or facility code in the previous
entry and the card number of the access control card that will be given to the user in the card
number entry below then press [ENTER].
UN00001 Card
no: 4294967295
The card number when blank or deleted is shown as the maximum card number of
4294967295 and to default or clear the card number press the [DISARM] key.
If you are not aware of the card number you can present the card to any reader that is
programmed in the system. The card number that is read will be displayed in the location only
if it is not already programmed or allocated to a user.
The Protégé System also supports the loading of cards automatically. This will increment the
user number and wait for the next valid presentation of a card that is not currently in the
database and storing the details for that user in the current record.
• To enable automatic loading of the card information press the [ARM] key and a
brief message will be shown with the current automatic card loading status.
Autoload mode
enabled.
Protégé Integrated System Controller Reference Manual
44