PRT CTRL Integrated Controller Reference Manual

User Area
The user area can be used to disarm the selected area automatically on login to a keypad or
when access is granted at a door or reader. For this feature to operate correctly the
programmed area must belong to the user’s disarm area group. This feature is ideal for
securing many individual offices yet arming all of them when all employees exit and disarming
only the person’s office that they are allowed to access while other offices remain secure and
protected.
UN00001 Area
None
Use the [1] and [3] keys to scroll the user area selection and press [ENTER] to select the
area that is displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
User Expiry Date
Setting an expiry date for the user will prevent the user from gaining access to the system
past the date that is set. Use this feature to program cards for temporary employees, trade
people or contractors. This feature can also be used for membership processing to prevent
access once the membership period has expired.
UN00001 Expiry
date: --/--/----
Use the numerical keys to enter a valid date and then press [ENTER] to program the date. If
you do not program a time in the following section the user will expire at midnight on the
date that is programmed. For more information about entering the date information refer to
the section Date and Time Data Entry on Page 407.
If you do not enter a valid date an error message will be shown, pressing the [STAY] key will
allow you to clear your entry or set the default value.
User Expiry Time
Setting an expiry time for the user will prevent the user from gaining access to the system
past the date and time that is set. If you have created a temporary user by programming the
expiry date in the previous screen, use the 24-hour clock method (i.e. 4:15pm = 16:15) to
program the time that the user code (PIN) and its programmed rights become invalid. If the
expiry date in the previous screen is left blank, the system ignores the time.
If the time screen is left blank, but an expiry date has been programmed, the user code (PIN)
expires at 23:59.59 on the date programmed.
If the Loiter Mode option is turned on for this user, the expiry time is ignored and the user
code (PIN) expires at 23:59.59 on the programmed date.
Use this feature to program cards for temporary employees, trade people or contractors. This
feature can also be used for membership processing to prevent access once the membership
period has expired.
UN00001 Expiry
time: --:--
43 Protégé Integrated System Controller Reference Manual