PRT CTRL Integrated Controller Reference Manual

Use this feature to program cards for temporary employees, trade people or contractors. This
feature can also be used for membership processing to prevent access once the membership
period has expired.
UN00001 Axs1 Sta
time: --:--
Use the numerical keys to enter a valid time in a 24HR format and then press [ENTER] to
program the time. If you do not program a time in the following section the user will expire at
midnight on the date that is programmed. For more information about entering the date
information refer to the section Date and Time Data Entry on Page 407.
If you do not enter a valid time an error message will be shown, pressing the [STAY] key will
allow you to clear your entry.
Access Level 1 End Date
Setting the access level end date will disable the access level for this user at 23:59 on this
date. If a end time is also set the access level will be disabled at that time on this date.
UN00001 Axs1 End
date: --/--/----
Use the numerical keys to enter a valid date and then press [ENTER] to program the date. If
you do not program a time in the following section the access level will expire at midnight on
the date that is programmed. For more information about entering the date information refer
to the section Date and Time Data Entry on Page 407.
If you do not enter a valid date an error message will be shown, pressing the [STAY] key will
allow you to clear your entry or set the default value.
Access Level 1 End Time
Setting the access level end time will disable the access level for the user once this time has
past. If both the end time and date are set then the access level will be disabled after the
date and time has past. If only the time is set then the access level will be disabled after this
time has past.
UN00001 Axs1 End
time: --:--
Use the numerical keys to enter a valid time in a 24HR format and then press [ENTER] to
program the time. If you do not program a time in the following section the user will expire at
midnight on the date that is programmed. For more information about entering the date
information refer to the section Date and Time Data Entry on Page 407.
If you do not enter a valid time an error message will be shown, pressing the [STAY] key will
allow you to clear your entry.
Access Level 2,3 and 4
Each user can be assigned up to four access levels. Each of these access levels has an
independent start and end time. These are programmed after Access Level 1. Leave the
access level as None to disable it.
Protégé Integrated System Controller Reference Manual
42