PRT CTRL Integrated Controller Reference Manual

1. Set battery
charge 700mA: N
To change this option press the [1] key or to scroll the options press the [] and [] arrow
keys. To return to the options screen press the [STAY] key. To save the options move off the
screen using a navigation key or press the [ENTER] key.
PGM and PGM Group Entry
PGM and PGM Group Entry is done by selecting the module type and then the address and
actual PGM number on the device. For example to program the second lock output on the
fourth reader expander you would enter RD004:02 where the RD is entered using the ascii
mode similar to the text entry and the 004 and 02 are entered using normal decimal mode
entry.
In the following example we will program the Green LED on the LCD keypad at address 001 to
activate when the area is disarmed. We program this option in the area configuration.
AR001 Disarmed
pgm: --000:00
In the above screen the default value for a PGM is shown this is –000:00. To default the PGM
entry press the [DISARM] key or to recall the currently programmed value press the [ARM]
key. Pressing the [5] key twice will put a ‘K’ in the first location. Using the table in the Object
Notation Section on Page 402 the keypad is referenced as a KP. Press the [] arrow key to
move to the next location.
AR001 Disarmed
pgm: K-000:00
Pressing the [7] key once will show the ‘P’ on the screen, move the cursor to the right using
the [] key.
AR001 Disarmed
pgm: KP000:00
Complete the entry by pressing [0], [0], [1] then the PGM output number by pressing [0]
and [3] for the green LED.
To enter a PGM group complete the same procedures as above however use the PG for the
prefix in the module type, the screen will change to only have 3 digits allowing the PGM group
to be entered. See below for an example of PGM group 4 at the same location as above.
AR001 Disarmed
pgm: PG004
Protégé Integrated System Controller Reference Manual
410