PRT CTRL Integrated Controller Reference Manual

Hexadecimal Data Entry
Hexadecimal entry is required in only a few key locations however it is an important part of
the data entry process. Use the 0-9 keys for the numerical data portion and the 2 and 3 key
to obtain the letters A-F (Press the 2 and 3 keys multiple times to cycle through the available
values A, B,C and D, E, F).
Pressing the [STAY] key will set the minimum value, pressing the [FORCE] key will set the
maximum value and pressing the [ARM] will recall the value that was previously set.
Hexadecimal entry can take on any number of digits from 1 up to 32 depending on the
location that the hexadecimal number is being entered. In the following example a number of
21B64C90 is being entered in to the host id setting in the panel configuration.
Panel host
ID: 00000000
When you enter in to a hexadecimal entry screen the cursor will be located on the first
hexadecimal digit that can be set. For our example the default host id of 00000000 will be
replaced with our new host id of 21B64C90.
The arrow keys (left and right) can be used to move the cursor to the desired position in the
hexadecimal number if only one part of the existing value requires modification. For example
to program a host id of 00000001 you can right arrow to the last digit and simply press the
[1] key to set the digit.
Panel host
ID: 00000000
In the above screen the cursor will be flashing over the first 0 of the 00000000 press the [2]
key, the 0 will be replaced with a 2. The cursor will NOT move to the right automatically you
must press the right arrow key. Repeat the above procedure for the 1 value pressing the right
arrow key when done.
Panel host
ID: 21B00000
When entering the B press the [2] key 3 times and the display will show the B at the third
position pressing the right arrow once the B is shown in the display. Repeat the same
procedures above for the remainder of the value.
Panel host
ID: 21B64C90
Press the [ENTER] key to save the value shown.
List Data Entry
Protégé Integrated System Controller Reference Manual
408