PRT CTRL Integrated Controller Reference Manual

If you have not moved off the screen and want to recall the previous setting you can press
the [ARM] key to recall the currently set value.
Name and Text Data Entry
Many of the records within the Protégé System can have an assigned name or text. As and
example users, zones, areas and many other records have an associated text name that is
used in the Protégé System.
Access Code and PIN Number Entry
Programming the name or text value is completed using
the numerical keys on the keypad in the same manner
that you select a name or store a name using a mobile
telephone keypad.
Entering text data is done by pressing keys multiple times
to show the character required. The display will change as
the key is pressed.
Using the character key map shown, to enter the name
John, the [5] key is pressed once, move the cursor one
location to the right with the [] key. Press the [6] key
seven times and repeat the procedure for the other
characters in the text entry.
Access codes or PIN numbers are entered using the 0-9 keys. Pressing the [DISARM] key will
delete the PIN number.
PIN number entry can take on any number of digits from 1 up to 8 and can be preceded by
any number of zeros. For example the codes 1, 01 and 0001 are all unique within the Protégé
System.
In the following example the user code 2580 is programmed for UN00003 (Demo User by
Default) over writing the default demo user code of 111111.
UN00001 User
code: 111111
When you enter in to the PIN number entry screen the cursor will be located on the first
programmed digit of the PIN number or if the PIN number is not set it will be at the first
position available. For our example the demo user default PIN number of 111111 is going to
be replaced with 2580.
UN00001 User
code: 111111
In the above screen the cursor will be flashing over the first 1 in the PIN number. We need to
erase the PIN number that is currently programmed by pressing the [DISARM] key.
Protégé Integrated System Controller Reference Manual
406