PRT CTRL Integrated Controller Reference Manual

DATA ENTRY
Introduction
When programming the Protégé System using the LCD Keypad the information is entered
using predefined methods, these include List Entry (a list of predefined values or values
looked up from another record), Decimal Entry, PGM and PGM Group, Protégé Notation and
Module Notation. Each of these entry methods use predefined keys and functions as outlined
in the following sections.
Decimal Data Entry
Decimal numbers are entered using the 0-9 keys. Pressing the [STAY] key will set the
minimum value, pressing the [FORCE] key will set the maximum value and pressing the
[ARM] will recall the value that was previously set.
Decimal entry can take on any number of digits from 1 up to 32 depending on the location
that the number is being entered. In the following example a number of 120 is being entered
in to the door unlock time.
DR001 Unlock
time: 120 secs
When you enter in to a decimal entry screen the cursor will be located on the first decimal
digit that can be set. For our example the default door time is 005 seconds however we want
to set the unlock time to 120.
DR001 Unlock
time: 005 secs
In the above screen the cursor will be flashing over the first 0 of the 005 press the [1] key,
the 0 will be replaced with a 1 and the cursor will move to the right over the next 0.
DR001 Unlock
time: 105 secs
Pressing the [2] will replace the 0 with a 2 and then the cursor will move to the right once
again and be positioned over the 5 now press the [0] and the completed value will be seen
on the screen of 120 as shown below.
DR001 Unlock
time: 120 secs
Once the information is entered as above the data is not saved until you move to another
screen. Once you have moved off the screen by pressing the [ENTER] key or pressing the
right, left, up or down key the data is saved.
405 Protégé Integrated System Controller Reference Manual