PRT CTRL Integrated Controller Reference Manual

GG
XYZ
S
Group or Partition (Area) number composed using two
hex digits 0-9 and B-F. Use 00 to indicate that no
specific group or partition information is applicable.
Zone Number (Event Reports) or User Number for
(Open / Close Reports) composed using the digits 0-9
and B-F. Use 000 to indicate that no specific zone or
user information applies.
Sum of all digits + S such that a MOD 15 will result in a
0. Not a 0 shall be transmitted as a 10 and valued as a
10 for checksum purposes even though it is displayed
and printed as a '0'.
The Protégé System controller does not change or alter messages from this format when
Contact ID is selected as the reporting format.
SIA L2 (SIA Level Two)
SIA Level Two is a modem based reporting format that is ideal for large scale integrated
solutions such as the Protégé System. Comprising of a multiple message format and tonal
acknowledgement the SIA (Security Industry Association) format provides many reporting
features ideal for access control, automation and large burglary.
The SIA protocol is pre-defined and requires no further programming to operate with the
exception of an account code for an area or service that is running SIA. It is also possible to
assign a special code to the zone type being used for reporting if needed. The custom types
are shown in the table following the zone types assigned to each module.
Zones are reported using the standard burglary codes as detailed below. Openings, closings
and other area operations are reported used the area reporting codes.
Alarm / Open BA BR
Tamper BT BJ
Bypass BB BR
SIA Level 2 Message Format
The format of the SIA messages can vary greatly depending on the leading zero's
configuration for each of the various data code packets that can be sent. Given the large
number of zones, users and areas the Protégé System attempts to use the maximum of these
that is available. Some provision is provided to reduce the size of these fields (Account Code
to 4 Digits, Zone Numbers to 4 Digits) to allow easy integration with monitoring software.
When configuring the automation software at the monitoring station for the information
coming from the receiver the following format should be used. In most cases a 4 digit account
code can be set in the service and used as default.
The first transmitted data is always the account code block, this is not shown and typically
prefixed with a D or F dependent on the size of the account code. This can be either 4 or 6
digits (D# or F#).
N ri GGG BA WXYZ ....
Where:
N
Signifies a new event or an O will signify a old event
that is being reported.
Protégé Integrated System Controller Reference Manual
386