PRT CTRL Integrated Controller Reference Manual

Zone(s) Open Display
• If a zone is not closed and secure, the keypad immediately beeps and displays the first
open zone.
*CP001:01
is OPEN
• The keypad then automatically scrolls through the different possible actions that the
user is allowed to take to continue with the arming process.
Press [ARM] to
Re-test zone(s)
• Press the [ARM] key to retest all the zones. Any exit zone with the exit delay or delay
zone type programmed will not prevent the system from arming if the Exit Zone option
is enabled. A bypassed zone will not prevent the system from arming unless the
number of bypassed zone(s) exceeds the maximum number allowed for the selected
area. To program a maximum number bypassed zones that an area can have refer to
the Bypass Count option in Area Programming on Page XX.
Press [] for
next zone(s)
• Press the [] key, to scroll through the zones that remain open when arming the area.
Press [FORCE] to
force arm area.
• If the zone is still open and the area disarmed, you can force the area to arm. Press
the [FORCE] key to force arm the area. Force arming must be enabled for the area
being controlled and the user must have access to this operation. Refer to the Force
Arming section on page 31 for more information.
Press [MENU, 7]
to bypass zones.
System Trouble
• Press [MENU, 7] to access the bypass menu. Accessing the bypass menu allows you
to bypass zones and trouble zones. Refer to the section Bypassing Zones on Page XX
for more information.
When arming the system, if a general, system or access trouble is present, the keypad
momentarily displays a trouble message and returns to the Area Status screen.
Cannot ARM Area
System Trouble
37 Protégé Integrated System Controller Reference Manual