PRT CTRL Integrated Controller Reference Manual

Please refer to the section Reporting Codes on page XX for additional information on the
reporting codes used for Contact ID.
Control Panel Zones
The control panel will report all zones from 1 to 16 using any of the available table
configurations.
Zone Number Contact ID Code Reporting Point Number
CP001:01 130 (Burglary) 001
CP001:02 130 (Burglary) 002
CP001:03 130 (Burglary) 003
CP001:04 130 (Burglary) 004
CP001:05 130 (Burglary) 005
CP001:06 130 (Burglary) 006
CP001:07 130 (Burglary) 007
CP001:08 130 (Burglary) 008
CP001:09 130 (Burglary) 009
CP001:10 130 (Burglary) 010
CP001:11 130 (Burglary) 011
CP001:12 130 (Burglary) 012
CP001:13 130 (Burglary) 013
CP001:14 130 (Burglary) 014
CP001:15 130 (Burglary) 015
CP001:16 130 (Burglary) 016
In the above table a reporting code of 999 indicates that the zone is outside the maximum
zones that can be reported in some cases the zone number will reflect the module address
that the zone was activated from to aid in service.
Keypad Zones
The keypad will report zones from 1 to 4 on the first 2 modules, all modules above address
KP006 will be reported using the default code of 999.
Zone Number Contact ID Code Reporting Point Number
KP001:01 130 (Burglary) 017
KP001:02 130 (Burglary) 018
KP001:03 130 (Burglary) 019
KP001:04 130 (Burglary) 020
KP002:01 130 (Burglary) 021
KP002:02 130 (Burglary) 022
| | | | | | | |
KP002:04 130 (Burglary) 040
KP003:01 130 (Burglary) 999
| | | | | | | |
KP250:04 130 (Burglary) 999
In the above table a reporting code of 999 indicates that the zone is outside the maximum
zones that can be reported for the module type.
16 Zone Expander
The 16 zone expander will report zones from 1 to 16 on the first 20 modules, all modules
above address ZX004 will be reported using the default code of 999.
Zone Number Contact ID Code Reporting Point Number
365 Protégé Integrated System Controller Reference Manual