PRT CTRL Integrated Controller Reference Manual

• When the 24Hr disable/disarming process is completed the 24Hr area status will
change to "24Hr Disabled".
*Area 001
24HR Disabled
• Press the [] key to return to the area status display.
• Press the [CLEAR] key to exit.
To disarm the 24Hr processing of the selected area, you must be able to access it,
refer to the Area Security section on page 30. The user must have the access 24Hr
Processing Option enabled.
The Protégé System protects the area programming by preventing ANY
programming to be done when either the Area or the 24Hr processing of an area is
enabled. You must always disable the 24Hr processing and disarm an area before
the area can be programmed.
Area Group Arming
Area group processing allows you to arm or disarm a group of areas rather than one area at a
time. The area group controlled is the area group assigned to the keypad used to access the
system. To arm the area group the user must be able to access ALL the areas in the area
group. The user must have the access area group option enabled to access the area group
function.
• Access the area status display screen as explained in section Area Status Display
on page 29.
*Area 001
is DISARMED
• From the Area Status screen, press the [] key to select the Area group control
screen.
Press [ARM] or
[DISARM] to
The screen will scroll between the screen above and below prompting the user to
press the [ARM] or [DISARM] key to control the area group that is shown.
control group
*Area Group 001
• From the Area Group Control screen, press the [ARM] key to arm the selected area
group. Pressing the [ARM] key starts the arming process for each area in the area
group.
35 Protégé Integrated System Controller Reference Manual