PRT CTRL Integrated Controller Reference Manual

BYPASS
Introduction
To access the bypass menu, login using a valid code that is allowed bypass menu access and
then select [MENU, 7]. You can then browse the bypass menu and select the bypass that you
want to perform on your Protégé System.
Bypass Menu
The bypass menu consists of 2 entries that can be scrolled to using the [] and [] arrow or
selected directly using the shortcut keys shown in the figure below.
MENU 7
ZONE
BYPASSING
MENU 7, 1
BYPASS ZONE
MENU 7, 2
BYPASS
TROUBLE ZONE
Bypassing Zones
Figure 17 - Zone Bypassing Menu Overview
To bypass zones select [MENU, 7, 1] then using the [] and [] arrows to scroll the
available zones. A zone can be bypassed by pressing the [1] key to bypass the zone and then
the [2] key to remove the zone bypass. A zone can also be bypassed in latch mode by
pressing the [3] key. If a zone is bypassed normally [1] the zone bypass will be removed the
next time the area disarms, please not all areas that have this zone programmed must disarm
for the bypass to be removed.
• Select the bypass zone menu [MENU, 7, 1]. The display will show the first zone in
the system.
Warehouse PIR
is not BYPASSED
• If a normal bypass is required press the [1] key the zone will then toggle state and
the display will show the bypassed message below.
Warehouse PIR
is BYPASSED
355 Protégé Integrated System Controller Reference Manual