PRT CTRL Integrated Controller Reference Manual

D/S Start Month
None
Use the [1] and [3] keys to scroll the starting month until you reach the required selection
and press [ENTER] to proceed to the next daylight savings screen. For more information
about the list control data entry refer to the section List Control Data Entry on Page 406.
Daylight Savings End Day
The end day selects the day of the month that daylight savings will end on. Daylight savings
is programmed to start on a day and end on a day for each time zone.
D/S Ends on
None
Use the [1] and [3] keys to scroll the ending day until you reach the required selection and
press [ENTER] to proceed to the next daylight savings screen. For more information about
the list control data entry refer to the section List Control Data Entry on Page 406.
Daylight Savings End Month
The end month selects the month that daylight savings will end in.
D/S End Month
None
Use the [1] and [3] keys to scroll the ending month until you reach the required selection and
press [ENTER] to proceed to the next daylight savings screen. For more information about
the list control data entry refer to the section List Control Data Entry on Page 406.
Daylight Savings Options
Currently all daylight savings options are reserved.
D/S Options
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1, 2, 3, 4, 5, 6, 7 and 8 – Reserved Do Not Modify
Enabled Reserved.
Disabled Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
353 Protégé Integrated System Controller Reference Manual