PRT CTRL Integrated Controller Reference Manual

*Area 001
24HR Busy
• When the enable/arming process is completed the 24Hr area status will change to
"24Hr Enabled".
*Area 001
is ENABLED
• Press the [] key to return to the area status display.
• Press the [CLEAR] key to exit.
To enable the 24Hr processing of the selected area, you must be able to access it,
refer to the Area Security section on page 30. The user must have the access 24Hr
Processing Option enabled.
The Protégé System protects the area programming by preventing ANY
programming to be done when either the Area or the 24Hr processing of an area is
enabled. You must always disable the 24Hr processing and disarm an area before
the area can be programmed.
24HR Disabling
The Protégé System continually checks zones and trouble zones for a tamper condition
regardless of the armed status of the area. The 24Hr processing monitors trouble zones as
well as tamper and shorts on zones within the selected area. This allows the tamper zones to
generate an alarm even if the area is disarmed. To disable the 24Hr processing of an area,
you must have access to the area and the user must have the option to access the 24Hr
Processing enabled.
• Access the area status display screen as explained in section Area Status Display
on page 29. Using the scroll keys [ ] select the area that you want to disarm.
*Area 001
is DISARMED
• From the Area Status screen, press the [] key to select the 24Hr Status screen.
*Area 001
24HR Enabled
• From the Area 24Hr Status screen, press the [DISARM] key to disarm/disable the
24Hr processing in the selected area. Pressing the [DISARM] key starts the
disable/disarming process.
*Area 001
24HR Busy
Protégé Integrated System Controller Reference Manual
34