PRT CTRL Integrated Controller Reference Manual

CF001 Set Bit 1
bit: 255
To modify this parameter (000 to 255), use the keypad as explained in section Entering
Decimal Numbers on Page 405 and press [ENTER].
Parity Clear Bit 1 to 4
There can be up to 4 defined clear bits in the received data. A clear bit defines a location in
the received data that must always be cleared (or a logical ‘0’). They are all programmed
using the same method and therefore the manual only covers programming the first clear bit.
The clear bit defines the location of the bit in the received data. The count starts at zero. If
there is no set bit this value to 255.
CF001 Clr Bit 1
bit: 255
To modify this parameter (000 to 255), use the keypad as explained in section Entering
Decimal Numbers on Page 405 and press [ENTER].
A module update must be performed to each reader expander that the custom format is
selected for before this can be used.
Protégé Integrated System Controller Reference Manual
336