PRT CTRL Integrated Controller Reference Manual

Custom Reader Format
The Protege System Controller and Protege Reader Expansion Modules can support custom
Wiegand Card Reader formats for the times when the format required is not one of the many
available preset formats.
One custom format can be added per controller and used by any reader expander in the
system.
Interface Type
To access the custom reader format programming login using a valid installer code and then
select [MENU, 4, 9, 5]. The screen displays the first entry to modify as there is only one
panel no record selection is required. The first item that is programmable is the output
format.
The data can either be output as Wiegand (D0 and D1) or Magnetic Data (Clock and Data).
CF001 Type
Wiegand
Use the [1] and [3] keys to scroll the format type until you reach the required format and
press [ENTER] to proceed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
Data Length
The data length defines the total number of bits that are sent by the card reader for each card
badge.
CF001 Length
bits: 026
To modify the length (000 to 255), use the keypad as explained in section Entering Decimal
Numbers on Page 405 and press [ENTER].
Facility Code Start
The facility code start defines the index where the facility code data starts in the data
transmitted. The count starts at zero.
CF001 Site Start
bits: 001
To modify this parameter (000 to 255), use the keypad as explained in section Entering
Decimal Numbers on Page 405 and press [ENTER].
Facility Code End
The facility code end defines the index where the facility code data ends in the data
transmitted. The count starts at zero.
333 Protégé Integrated System Controller Reference Manual