PRT CTRL Integrated Controller Reference Manual

To modify the panel IP gateway use the decimal entry from (000 to 255), use the keypad as
explained in section Entering Decimal Numbers on Page 405 and press [ENTER]. Setting an
address of 255 will disable the communication.
Panel Upload ID
The panel upload ID is used as a security key in combination with the host verify ID for
communication with the Protégé System Management Suite. The upload and host ID keys
prevent the remote connection of a Protégé System Management Suite other than that which
has the same 32 bit keys.
Panel upload
ID: 00000000
To modify the panel upload id, use the keypad as explained in section Entering Hexadecimal
Numbers on Page 405 and press [ENTER].
Host Verify ID
The host verify ID is used as a security key in combination with the panel upload ID for
communication with the Protégé System Management Suite. The upload and host ID keys
prevent the remote connection of a Protégé System Management Suite other than that which
has the same 32 bit keys.
Host verify
ID: 00000000
To modify the host verify id, use the keypad as explained in section Entering Hexadecimal
Numbers on Page 405 and press [ENTER].
Module UDP Port
This is the UDP port that all Ethernet enabled modules will communicate with the Protégé
System Controller. When the UDP port is changed all modules will need to be updated with
the correct port.
Module UDP
port: 09450
To modify the port (000 to 65565), use the keypad as explained in section Entering Decimal
Numbers on Page 405 and press [ENTER].
Touch Screen UDP Port
This is the UDP port that Protégé Touch Screen Keypads (PRT-TLCD) with the Protégé System
Controller over. Touch Screens also communicate over the Module UDP port programmed
above for basic module functions. When the UDP port is changed all modules will need to be
updated with the correct port.
PRT-TLCD
port: 09460
Protégé Integrated System Controller Reference Manual
328