PRT CTRL Integrated Controller Reference Manual

that a service that uses the setting is restarted (for example changing the TCP/IP Address
requires that the TCP/IP service is restarted).
AC Failure Time
The AC Failure time allows the installer to program a time that AC mains voltage must have
failed before activating the AC Failure Trouble Zone. Set this to a larger value for locations
that experience frequent but short interruptions in power or that operates on a generator
frequently.
AC Failure
time: 030 secs
To modify the AC Failure time (000 to 255 Seconds), use the keypad as explained in section
Entering Decimal Numbers on Page 405 and press [ENTER].
AC Restore Time
The AC Restore time allows the installer to program a time that AC must be present for after
a AC Failure before restoring the AC Failure Trouble Zone. Set this to a larger value for
locations that experience frequent but short interruptions in power or that operates on a
generator frequently.
AC Restore
time: 030 secs
To modify the AC Restore time (000 to 255 Seconds), use the keypad as explained in section
Entering Decimal Numbers on Page 405 and press [ENTER].
Battery Test Time
The battery test time allows the installer to program the duration of time in minutes between
each battery test that is performed. A battery test is performed immediately on power up of
the panel and then every programmed period. Each battery test takes 45 seconds and the
battery low/failure trouble zone will activate if the battery fails.
Battery Test
Time: 015 mins
To modify the Battery Test time (000 to 255 Minutes), use the keypad as explained in section
Entering Decimal Numbers on Page 405 and press [ENTER].
Default LCD Text Line One
The default LCD text for line one is shown on all PRT-KLCD keypads when they are first
connected to the system. This text should be changed to the name of the building, installation
or owners details. To view the information on setting the time, date or other variable text see
the formatting character information in the following section.
Def LCD Line 1
Protege System
To modify or enter a new name for the selected default LCD line item use the keypad as
explained in section Entering Text and Names on Page 406 and press [ENTER].
Protégé Integrated System Controller Reference Manual
324