PRT CTRL Integrated Controller Reference Manual

GENERAL PROGRAMMING
Introduction
The general programming menu contains programmable options for the automation PGM's
and the panel configuration options. The restart menu [MENU, 4, 9, 3] allows the system
controller to be restarted.
MENU 4, 9
SYSTEM
PROGRAMMING
MENU 4, 9, 1
AUTOMATION
PROGRAMMING
MENU 4, 9, 2
PANEL
PROGRAMMING
MENU 4, 9, 3
RESET
SYSTEM
Figure 14 – General System Programming Menu Overview
A panel restart is required for the TCP/IP address change to take affect once
programmed in the panel configuration menu. The panel will remain operational on
the previously assigned IP address until it is restarted.
To go to the general menu select [MENU, 4, 9]. You can then select from the menu items
presented or scroll the menu using the [] and [] keys.
Automation
To access the automation programming login using a valid installer code and then select
[MENU, 4, 9, 1]. The screen displays “Automation to modify” as shown in the following
example.
Automation to
modify: AT001
Every time you press the Enter key, the next screen appears. The different screens are
described in the following sub-sections. Programming the automation settings in the Protégé
System allow you to configure the automation that is shown on the system keypads.
Selecting an Automation Entry to Modify
Each automation entry is assigned a unique automation number from 001 to 250.
Protégé Integrated System Controller Reference Manual
320