PRT CTRL Integrated Controller Reference Manual

FN001 Func Type
Elevator Ctrl
Use the [1] and [3] keys to scroll the function types until you reach the door control selection
and press [ENTER] to select the function type displayed and proceed to the next
programmable option for the elevator control function. For more information about the list
control data entry refer to the section List Control Data Entry on Page 406.
Function Mode
The function mode determines how this function operates with the system controller. By
default a function is set to normal operation. Normal operation will mean the function is
started if it was running when the system restarts or is completely powered down (AC Failure
and Battery Failure). The Run Once mode of operation will allow the function to run once and
then wait to be stopped and started by the user or operator.
FN001 Func Mode
Normal
Use the [1] and [3] keys to scroll the function mode until you reach the normal selection and
press [ENTER] to proceed to the next programmable option for the elevator control function.
For more information about the list control data entry refer to the section List Control Data
Entry on Page 406.
Elevator Action
The action determines what action is performed on the elevator group that is programmed as
a result of the Input PGM. An action MUST be selected for the programmable function to
operate correctly.
FN001 Action
None
Use the [1] and [3] keys to scroll the action types until you reach the required action that
you want to be performed and then press [ENTER] to proceed to the next programmable
option for the eleavtor control function. For more information about the list control data entry
refer to the section List Control Data Entry on Page 406.
Logic Action
Follow and Test
Description
The floor group status follows the programmed input one state
and will retest the input state every 30 second interval and
change the floor group state accordingly.
Input One
ON
OFF
Floor Group
UNLOCKED
LOCKED
Test Action - If the floor group state is changed externally or is
part of another programmable function the programmable
function will only restore the output state after 30 seconds has
elapsed. This time is only used if the programmable function was
NOT responsible for the change in state. If a door has a door
unlock time and the door mode is set to timed this will unlock the
Protégé Integrated System Controller Reference Manual
314