PRT CTRL Integrated Controller Reference Manual

FN001 Func Mode
Normal
Use the [1] and [3] keys to scroll the function mode until you reach the normal selection and
press [ENTER] to proceed to the next programmable option for the door control function. For
more information about the list control data entry refer to the section List Control Data Entry
on Page 406.
Control Zone
The control zone’s state will be set to be opened or closed according to the start of the
Control PGM. If the PGM is OFF the zone will be closed. If the PGM is ON, TIMED ON or
PULSED ON the zone will be open. The zone must be placed in an armed area to use it for
control or reporting.
FN001 Control
Zone CP001:01
To modify the input Zone, use the settings as explained in section Entering Zones on Page
411.
Control PGM
The Control PGM’s state will be followed by the Control Zone.
FN001 Control
pgm: CP001:01
To modify the Control PGM or PGM Group, use the settings as explained in section Entering
PGM and PGM Groups on Page 410
Miscellaneous Options
These options are for the function.
FN001 Misc
[1--------]
Option 1 – Log Zone Events
Enable Zone events when the zone changes state.
Disable any Zone Events.
Option 2 - 8 – Reserved
Reserved.
Reserved.
Elevator Control
To program the Elevator Control function ensure that the function you have selected is halted.
Select the function type selection screen as shown below for Elevator Control.
313 Protégé Integrated System Controller Reference Manual