PRT CTRL Integrated Controller Reference Manual

When the door closes, the zone will also close. Place this zone in a reportable area to enabled
reportable events from the virtual door.
FN001 Forced
Zone CP001:01
To modify the input Zone, use the settings as explained in section Entering Zones on Page
411.
Virtual Door Unlock Time
The unlock time determines how long the lock that controls the virtual door will remain
unlocked for when a user access's the door.
FN001 Unlock
time: 005 secs
To modify the unlock time (000 to 255 Seconds), use the keypad as explained in section
Entering Decimal Numbers on Page 405 and press [ENTER]. Setting a 000 value will result in
the door not unlocking when a users access's the door.
Virtual Door Maximum Open Time
The maximum open time is programmed to allow the door to be left open for a certain period
before it will generate a door left open condition. When the left open condition is reached this
will activate the alarm PGM and open the left open zone.
DR001 Pre-Alarm
time: 030 secs
To modify the pre-alarm time (000 to 255 Seconds), use the keypad as explained in section
Entering Decimal Numbers on Page 405 and press [ENTER]. Setting a 000 value will result in
the pre-alarm feature not operating.
Virtual Door Lock PGM or PGM Group
You can assign a PGM or PGM group that controls the physical electric lock for the door.
FN001 Door Lock
pgm: --000:00
To modify the door lock PGM or PGM Group, use the settings as explained in section Entering
PGM and PGM Groups on Page 410.
Alarm PGM or PGM Group
You can assign a PGM or PGM group that will activate when the door goes into either a left
open or forced condition. Use this to warn the user to close the door. See miscellaneous
options below for configuring how the PGM is activated.
DR001 Pre Alarm
pgm: --000:00
311 Protégé Integrated System Controller Reference Manual