PRT CTRL Integrated Controller Reference Manual

FN001 Stage 6
pgm: --000:00
To modify the Stage 6 PGM, use the settings as explained in section Entering PGM and PGM
Groups on Page 410.
Stage 7 PGM
The seventh PGM in the 8 PGM outputs that can be programmed for the ripple control
function.
FN001 Stage 7
pgm: --000:00
To modify the Stage 7 PGM, use the settings as explained in section Entering PGM and PGM
Groups on Page 410.
Stage 8 PGM
The eigth PGM in the 8 PGM outputs that can be programmed for the ripple control function.
FN001 Stage 8
pgm: --000:00
To modify the Stage 8 PGM, use the settings as explained in section Entering PGM and PGM
Groups on Page 410.
Door Control Function
To program the door control function ensure that the function you have selected is halted.
Select the function type selection screen as shown below for Door Control.
FN001 Func Type
Door Control
Use the [1] and [3] keys to scroll the function types until you reach the door control selection
and press [ENTER] to select the function type displayed and proceed to the next
programmable option for the door control function. For more information about the list
control data entry refer to the section List Control Data Entry on Page 406.
Function Mode
The function mode determines how this function operates with the system controller. By
default a function is set to normal operation. Normal operation will mean the function is
started if it was running when the system restarts or is completely powered down (AC Failure
and Battery Failure). The Run Once mode of operation will allow the function to run once and
then wait to be stopped and started by the user or operator.
FN001 Func Mode
Normal
305 Protégé Integrated System Controller Reference Manual