PRT CTRL Integrated Controller Reference Manual

or other mechanical input that will result in the floor tempering
shutting down.
10 Fire Condition
A fire alarm condition has been activated that has caused the floor
tempering to shut down.
11 Mode Delay
The mode has changed during a controlled operation either from
Manual to Auto or Auto to Manual and the function has entered a
delay period.
Floor Temperature Register
The floor temperature register is the register that is updated by an analogue module input
channel connected to a temperature sensor located at the floor level which is operated by the
floor tempering system. The floor temperature is typically received from a sensor located
within the floor area being controlled.
FN001 Floor temp
reg: 00000
To modify the floor temperature register (00000 to 65535, use the keypad as explained in
section Entering Decimal Numbers on Page 405 and press [ENTER].
If you are unsure how the Floor Tempering function operates and what action is
going to be started as a result in the change in the input registers you can specify
the register to be a normal register outside the analogue module range. This will
allow an installer to modify the values with the Protégé System Management Suite
and visually see the mode change in the Floor Tempering without the need to
physically connect the Floor Tempering to mechanical devices.
Duct Temperature Register
The duct air temperature register is the register that is updated by an analogue module input
channel connected to a temperature sensor. The duct air temperature is typically from a
sensor located within the duct downstream (when operating in forward mode) of the duct fan.
FN001 Duct temp
reg: 00000
To modify the duct temperature register (00000 to 65535, use the keypad as explained in
section Entering Decimal Numbers on Page 405 and press [ENTER].
Value Compare Function
The compare value function allows the comparison of an input value with predefined values in
data registers. This allows the activation of a low and high PGM output when the comparison
is over the set point and the hysterisis time.
FN001 Func Type
Value Compare
299 Protégé Integrated System Controller Reference Manual