PRT CTRL Integrated Controller Reference Manual

FN001 Fresh temp
reg: 00000
To modify the fresh temperature register (00000 to 65535, use the keypad as explained in
section Entering Decimal Numbers on Page 405 and press [ENTER].
Economiser Damper Register
The Base data register is used as the first register in the list of registers used to configure,
program and control the RTHP. The only registers that are not included in the base registers
are ones that must link to an analog input or analog output for external sensors (Temp,
Humidity or Dampers). A base data register setting MUST be set.
FN001 Space rh
reg: 00000
To modify the base data register (00000 to 65535, use the keypad as explained in section
Entering Decimal Numbers on Page 405 and press [ENTER].
Floor Tempering Control Function
The Floor Tempering programmable function allows the direct control of a single stage floor
tempering system that controls a duct mounted heater and/or cooling compressor. The
support for one heating and one cooling state is provided as well as a forward and reverse
operation.
FN001 Func Type
Floor Temping
Use the [1] and [3] keys to scroll the function types until you reach the Floor Temping
selection and press [ENTER] to select the function type displayed and proceed to the next
programmable option for the Floor Temping control function. For more information about the
list control data entry refer to the section List Control Data Entry on Page 406.
Function Mode
The function mode determines how this function operates with the system controller. By
default a function is set to normal operation. Normal operation will mean the function is
started if it was running when the system restarts or is completely powered down (AC Failure
and Battery Failure). The Run Once mode of operation will allow the function to run once and
then wait to be stopped and started by the user or operator. Setting the run once option for
the RTHP will result in NO operation being performed and the function stopping a short time
after it is started.
FN001 Func Mode
Normal
Use the [1] and [3] keys to scroll the function mode until you reach the normal selection and
press [ENTER] to proceed to the next programmable option for the floor temping function.
For more information about the list control data entry refer to the section List Control Data
Entry on Page 406.
Protégé Integrated System Controller Reference Manual
294