PRT CTRL Integrated Controller Reference Manual

option for the area control function. For more information about the list control data entry
refer to the section List Control Data Entry on Page 406.
Logic Action
Follow and Test
Description
The area status follows the programmed input one state and will
retest the input state continually.
Input One
ON
OFF
Area Control
ARM
DISARM
Test Action - If the output state is changed externally or is part of
another programmable function the programmable function will
only restore the output state after 30 seconds has elapsed. This
time is only used if the programmable function was NOT
responsible for the change in state.
Not Follow and
Test
Performs the same function as above however the area control
function is inverted (NOT). This logic action is a test action,
consult the follow and test action for an explanation of the Test
Function.
Input One
ON
OFF
Area Control
DISARM
ARM
Pulse On
The pulse on action will arm the area only when the input one
has transitioned from an off to an on state. The area will not be
modified further from this state and will not be modified if it is
turned OFF by another function.
Input One
Area Control
ARM
Not Pulse On
The not pulse on action will disarm the area only when the input
one has transitioned from an off to an on state. The area will not
be modified further from this state and will not be modified if it is
turned ON by another function.
Input One
Area Control
DISARM
Pulse Off
The pulse on action will arm the area only when the input one
has transitioned from an ON to an OFF state. The area will not be
modified further from this state and will not be modified if it is
turned OFF by another function.
Input One
Area Control
ARM
Not Pulse Off
The not pulse off action will disarm the area only when the input
one has transitioned from an ON to an OFF state. The area will
not be modified further from this state and will not be modified if
it is turned ON by another function.
283 Protégé Integrated System Controller Reference Manual