PRT CTRL Integrated Controller Reference Manual

Area Control
RTHP Control
Floor Temping
Value Compare
Ripple PGM
Door Control
of the logic function however if the output is changed from the
state it will be updated 30 seconds later, this prevents endless
loops from occurring while still ensuring an output will result in it
being maintained.
Can be used to arm or disarm an area based on the status of a
PGM output. This can only check the area status in follow mode
every 60 seconds.
Use to manage a Roof Top Heat Pack air conditioning system and
can operate up to 4 stages of heat and cool as well as two stages
of dehumidification.
Use to manage a floor tempering system with single stage heat
and cool. Duct and floor sensors inputs as well as reverse and
forward operational modes.
A direct comparison between two data registers with
programmable hysterisis and activate time as well has a high and
low PGM output. Ideal for the control of lighting circuits based on
daylight sensor inputs
Ripples on and ripples off up to 8 PGM outputs from an enable
PGM. Ideal for staging on large current devices and multiple
lighting circuits.
Can be used to lock and unlock a door or door group based on
the status of a input.
The functions require specific programming for the type that is selected, the following details
the programming information for each function type.
• Logic Control (Page 278)
• Area Control (Page 282)
• RTHP Controller (Page 284)
• Value Compare (Page 299)
• Ripple PGM Output (Page 302)
• Door Control (Page 305)
• Floor Temping Control (Page 294)
Logic Control Function
To program the logic control function ensure that the function you have selected is halted.
Select the function type selection screen as shown below for logic control.
FN001 Func Type
Logic Control
Use the [1] and [3] keys to scroll the function types until you reach the logic control selection
and press [ENTER] to select the logic control function type displayed and proceed to the next
programmable option for the logic control function. For more information about the list
control data entry refer to the section List Control Data Entry on Page 406.
Function Mode
The function mode determines how this function operates with the system controller. By
default a function is set to normal operation. Normal operation will mean the function is
started if it was running when the system restarts or is completely powered down (AC Failure
and Battery Failure). The Run Once mode of operation will mean the function will only run
once and then wait to be stopped and started by the user or operator.
Protégé Integrated System Controller Reference Manual
278