PRT CTRL Integrated Controller Reference Manual

Selecting a Function to Modify
Each function is assigned a unique function number from 001 to 250. Your system will be
limited to specific number of functions that are defined in the selected profile. For information
on profiles refer to the section Advanced Programming Section on Page 275.
Function to
modify: FN001
Type the appropriate 3-digit function number or use the [] and [] keys to scroll the
available functions. When the desired function appears on the screen, press [ENTER] to
program and control the selected function.
Controlling Functions (Starting and Stopping)
For a function to start performing the actions that it is programmed for you must start the
function. This is achieved by using the [1] key to start a function and the [2] key to stop a
function.
Functions can not be programmed if they are running and a message warning the user that
the function can be viewed only. To edit the function you must press the [2] key to stop the
function, wait for the display to show the halted message and then proceed with
programming.
FN001 State
Halted
If the function is running and changes are made to the function the system will not save these
to the programmed function.
Type Of Function
The type of function that is programmed will determine the operation that this function will
perform. This will also determine the programming screens that follow in each of the sub
sections as the programming of functions can contain many features and options dependent
on this selection.
FN001 Func Type
None
Use the [1] and [3] keys to scroll the function types and press [ENTER] to select the function
type displayed. For more information about the list control data entry refer to the section List
Control Data Entry on Page 406.
The following table includes a complete explanation of each function type that is
programmable in the Protégé System.
Function Type
None
Logic Control
Description
The function will perform no actions and controls no resources.
This function can not be started or halted.
Performs logic operations on Programmable Outputs. Can be
used to AND, OR, XOR, FOLLOW, NOT FOLLOW the
programmable outputs and activate a programmable output as a
result of function. When using logic control that will follow a
status the system will activate the associated output as a result
277 Protégé Integrated System Controller Reference Manual