PRT CTRL Integrated Controller Reference Manual

PN001 Secondary
None
Use the [1] and [3] keys to scroll the secondary telephone number selection and press
[ENTER] to select the telephone number displayed. For more information about the list
control data entry refer to the section List Control Data Entry on Page 406. Programming a
secondary telephone number that uses the current telephone number being edited will
perform no function.
Telephone Number
Program the telephone number that you want to assign to this telephone number entry.
PN001 Number
Use the numeric keys [0] to [9] to enter the telephone number. When the number has been
programmed press the [ENTER] key. To clear the telephone number displayed press the
[DISARM] key.
When using a telephone number that requires a number to be dialled before gaining an
outside line program the individual number or series of numbers in to a telephone number
and call this 'PABX Access'. When programming the service or function that requires the
telephone number you will also be able to select a telephone number for PABX access.
Sequential Dialling Attempts
Sequential dialing is used by default and results in the reporting phone numbers programmed
in the service being dialed sequentially. In the following example, a service is programmed
with a two telephone numbers (Phone 1 and Phone 2) and a backup telephone number. The
number of dialing attempts is set to 8 and the Use Alternate Dialing Method option is
disabled.
Success After 5 th Dialling Attempt With Phone Number 1
In the following example, the Controller was able to communicate with the central station
with the programmed phone number 1 on the 5th attempt.
Dial
Attempt Phone Number Dialed
Result
Number
1 Phone Number 1 Fail
2 Phone Number 1 Fail
3 Phone Number 1 Fail
4 Phone Number 1 Fail
5 Phone Number 1 Success (Report OK)
Success After 1 st Dialling Attempt With Back Up Phone
In the following example, the Controller was able to communicate with the central station
only after the backup phone number was used. This resulted in the opening of the reporting
failure trouble zone as a result of the reporting failure. This is subsequently sealed on the
next valid report from the backup phone number.
261 Protégé Integrated System Controller Reference Manual