PRT CTRL Integrated Controller Reference Manual

SV001 Com
port: 09647
To modify the port configuration use the keypad as explained in section Entering Decimal
Numbers on Page 405 and Press [ENTER] to save the modified data.
Encryption Type
The encryption type defines the method of encryption on the data sent between the PC
Hotkeys application and the System Controller.
SV001 Encryption
Default
Use the [1] and [3] keys to scroll the encryption type selection and press [ENTER] to select
the type displayed. For more information about the list control data entry refer to the section
List Control Data Entry on Page 406.
Encryption Key
When AES 128, 192 or 256 bit Encryption is selected this defines the AES key that is used.
SV001 Crypt Key
To modify or enter a new key use the keypad as explained in section Entering Text and
Names on Page 406 and press [ENTER].
Door Group
When programmed this door group will restrict the doors that can be controlled by this
service. If the door is not in this door group it will not be controlled.
SV001 Door Group
None
Use the [1] and [3] keys to scroll the door group selection and press [ENTER] to select the
door group displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
PGM Range Start
When programmed the PGM range start defines the first PGM that can be controlled by this
service. Only PGM’s that are within the range (defined below) can be controlled by this
service (unless the PGM is set to –000:00).
SV001 Start
pgm: CP001:01
To modify the PGM, use the settings as explained in section Entering PGM and PGM Groups on
Page 410.
Protégé Integrated System Controller Reference Manual
258