PRT CTRL Integrated Controller Reference Manual

PGM Mapping Start
The PGM mapping start defines the first PGM that is mapped between the 2 controllers.
SV001 Start
pgm: CP001:01
To modify the PGM, use the settings as explained in section Entering PGM and PGM Groups on
Page 410.
PGM Mapping Count
The PGM Mapping count defines the number of PGM’s that are mapped between the 2
controllers. This count can extend past modules, refer to the PGM addressing to work out the
addressing of PGMs.
SV001 PGM Link
count: 008
Edit the polling time to a value of 10 to 255 seconds, any number below 10 will disable the
polling being sent to the controller. Use the keypad as explained in section Entering Decimal
Numbers on Page 405 and press [ENTER].
Poll OK PGM
The Poll OK PGM defines the PGM that is activated when communication is established
between the 2 controllers.
SV001 Poll OK
pgm: CP001:02
To modify the PGM, use the settings as explained in section Entering PGM and PGM Groups on
Page 410.
Poll Fail PGM
The Poll Fail PGM defines the PGM that is activated when communication fails between the 2
controllers.
SV001 Poll Fail
pgm: CP001:02
To modify the PGM, use the settings as explained in section Entering PGM and PGM Groups on
Page 410.
General Options
The general options define how the service operates.
SV001 General
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Protégé Integrated System Controller Reference Manual
256