PRT CTRL Integrated Controller Reference Manual

Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
When setting the log polling events and log acknowledgements the event buffer can
be filled very quickly. Use these options to check the connectivity of the service and
then turn them off after commissioning has been completed.
Area Group
An area group will define which areas this service will process when a reportable event is
generated. An area group of None (default) will result in all areas being sent with the service.
SV001 Area Grp
None
Use the [1] and [3] keys to scroll the area group selection and press [ENTER] to select the
area group displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
Reporting Table
With the size of the protégé system the maximum reporting points available in the Report IP
service format is easily exceeded, to allow flexibility a reporting table has been created to
allow information to be sent using pre-defined zone numbers or values. There are 2
predefined configurations for the reporting tables.
SV001 Reporting
table: 000
To modify the reporting table (000 to 007), use the keypad as explained in section Entering
Decimal Numbers on Page 405 and press [ENTER].
DC09 Receiver Number
When using the Reporting Protocol “SIA Over IP” program the DC09 Receiver Number as
instructed by the monitoring station.
SV001 DC09 Recv
no: 000000
To modify the receiver number, use the keypad as explained in section Entering Hexadecimal
Numbers on Page 408 and press [ENTER].
DC09 Line Number
When using the Reporting Protocol “SIA Over IP” program the DC09 Line Number as
instructed by the monitoring station.
SV001 DC09 Line
no: 000000
253 Protégé Integrated System Controller Reference Manual