PRT CTRL Integrated Controller Reference Manual

To modify the IP address use the keypad as explained in section Entering Decimal Numbers
on Page 405. Press [ENTER] to save the Octet that is being entered and move to the next
Octet or the next screen once all four have been completed.
Secondary Port
The Secondary port configures the reporting service with the remote port number to
communicate on for the secondary IP. By using this information in connection with the
secondary IP a specific route can be set for this connection.
SV001 Primary
port: 09647
To modify the port configuration use the keypad as explained in section Entering Decimal
Numbers on Page 405 and Press [ENTER] to save the modified data.
Back Up Service
A back up service can be programmed to allow the IP reporting functions to be backed up by
a telephone dialer or similar. Using a back up service can be beneficial to allow link failures
and internet access to be reported over an alternate connection.
SV001 Back Up
None
Use the [1] and [3] keys to scroll the service selection and press [ENTER] to select the
service to be used for back up. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Server Polling Time
The polling time is set to schedule periodic connections with the server. The polling messages
sent to the receiver will depend on the format. Some formats require that the polling time be
set at both the controller and receivers, in this case ensure that this setting matches the
setting provided by the central monitoring station company.
SV001 Polling
time: 120 secs
Edit the polling time to a value of 10 to 255 seconds, any number below 10 will disable the
polling being sent to the server. Use the keypad as explained in section Entering Decimal
Numbers on Page 405 and press [ENTER].
The polling time set will periodically send the polling message for the AlarmNZ IP
and Patriot LS30 reporting formats a standard contact ID message with the code
602 will be sent for area 00 and point 999. In some cases these are used only to
reset a polling time and not generated as alarms in the Central Station.
Report Fail PGM Output
The report fail output is activated when a message is not successfully reported to the
programmed server (and backup server). The PGM is deactivated when an acknowledge is
received.
Protégé Integrated System Controller Reference Manual
250