PRT CTRL Integrated Controller Reference Manual

Communications Port Parity
The communications port parity defines the parity configuration for the communication with
the GSM Modem. This should not be changed from default.
SV001 Parity
No Parity
Use the [1] and [3] keys to scroll the communication parity options and press [ENTER] to
select the parity displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
Data Options
The data configure various communication settings that affect the operation of the Intercom
Interface protocol.
SV001 Data
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 – Log Modem Communication Events
Enabled the service will log communication events that occur on the .
Disabled the communication events will not be logged.
Option 2,3,4,5,6,7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Report IP Service
The Report IP Service allows the Protégé System controller to send alarm and activation
information over an IP connected network. The Report IP Service supports multiple formats
and allows the connection to third party reporting if required.
To program the Report IP Service ensure that the service that has been selected is halted.
Press the [ENTER] key until the display shows the service type selection screen.
SV001 Ser Type
Report IP
Use the [1] and [3] keys to scroll the service types until you reach the Report IP selection
and press [ENTER]. For more information about the list control data entry refer to the section
List Control Data Entry on Page 406.
247 Protégé Integrated System Controller Reference Manual