PRT CTRL Integrated Controller Reference Manual

SV001 Access
pgm: --000:00
To modify the Access PGM, use the settings as explained in section Entering PGM and PGM
Groups on Page 410.
GSM Modem Reporting Service
To program the GSM Modem service ensure that the service that has been selected is halted.
Press the [ENTER] key until the display shows the service type selection screen.
SV001 Ser Type
GSM Modem
Use the [1] and [3] keys to scroll the service types until you reach the GSM Modem selection
and press [ENTER]. For more information about the list control data entry refer to the section
List Control Data Entry on Page 406.
The GSM Modem type that is connected must conform to the AT command set
defined by the Cellular Modem Standard. We recommend the Wavecom Fast Track
modem or similar with a suitable SEPARATE power supply and battery back-up. Do
not power the modem unit from the Controller Power Supply.
Communications Port Number
The communications interface port defines which serial port the controller will use for
communication with the GSM Modem that has been configured. Select the communication
port that will be plugged in to the intercoms communication interface or RS232 connection.
SV001 Port
Ext Port 1
Use the [1] and [3] keys to scroll the communication ports and press [ENTER] to select the
port displayed. For more information about the list control data entry refer to the section List
Control Data Entry on Page 406.
Communications Port Speed
The communications port speed defines the baud rate at which the GSM Modem operates. The
default value is 9600 bits per second and we recommend that this is not changed. If the
speed or configuration is different adjust this setting to suit the type of modem that is
connected however the majority of modems will default to 9600. If you are not sure about the
connection speed verify the modem operation using a terminal program such as (Terraterm or
Hyperterminal).
SV001 Speed
9600
Use the [1] and [3] keys to scroll the communication port speed options and press [ENTER]
to select the speed displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Protégé Integrated System Controller Reference Manual
246