PRT CTRL Integrated Controller Reference Manual

Use the [1] and [3] keys to scroll the different intercom types and press [ENTER] to select
the intercom displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
Validation Mode
Siedle
Sentex Infinity
Sentex Type L
Enterphone
Function
Select when connecting the Siedle range of intercoms.
Integrates to the Bus Control module by using an ACC-485
unit and appropriate RS232 cable to the PRT-COMM serial
interface.
Select when connecting to the Sentex Infinity Multiple Point
intercoms from Chamberlain group. Connects to the serial
RS232 output of the intercom, may need a suitable RS485
converter for distances above 15 meters.
Select when connecting to the Sentex Type L single channel
intercoms from Chamberlain group. Connects to the serial
RS232 output of the intercom, may need a suitable RS485
converter for distances above 15 meters.
Select when connecting to the Enterphone intercom
system. Connects to the serial RS232 output of the
intercom, may need a suitable RS485 converter for
distances above 15 meters. The Enterphone unit does not
support multi units and therefore does not need to have the
intercom address set.
Validation Mode
The Validation Mode determines how the intercom service will grant access and then provide
a credit to an elevator car. User Number will validate the user id from the Intercom System
with the exact user number in the Protégé System Controller, User PIN will validate the user
with a PIN number of a user and the User Card will validate the user based on the
programmed card number of a user.
SV001 Validate
User Number
Use the [1] and [3] keys to scroll the different Validation Types and press [ENTER] to select
the validation type displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Validation Mode
User Number
User Number Offset
PIN Number
Card Number
Function
The user number (index) in to the Protégé System
controller’s user table will be used. This is typically used
with fixed user id’s for intercom control of doors and floors.
The user number (index) in to the Protégé System
controller’s user table will be used and an offset can be
programmed. This is typically used with fixed user id’s for
intercom floors.
The PIN number of the programmed user will be used to
identify the user from the Intercom System.
The Card Number of the programmed user will be used to
identify the user from the Intercom System. The family
number should be set to 0 unless instructions for the
intercom type specify a family number.
241 Protégé Integrated System Controller Reference Manual