PRT CTRL Integrated Controller Reference Manual

If the PCI fails to reply to a command or does not send information within the poll
fail time the service will go in to a retry mode where it will continually attempt to
restart the PCI. This allows recovery of the PCI from a power failure or from being
used and reconfigured during a C-Bus Programming session.
PCI Fail PGM Output
The PCI fail output is activated if the PCI is disconnected and the system does not get a valid
response to a command. The PGM is deactivated when a valid command is received.
SV001 PCI fail
pgm: --000:00
To modify the PCI fail PGM, use the settings as explained in section Entering PGM and PGM Groups
on Page 410.
Intercom High Level Interface
To program the Intercom High Level Interface service ensure that the service that has been
selected is halted. Press the [ENTER] key until the display shows the service type selection
screen.
SV001 Ser Type
Intercom
Use the [1] and [3] keys to scroll the service types until you reach the Intercom selection and
press [ENTER]. For more information about the list control data entry refer to the section List
Control Data Entry on Page 406.
Service Mode
The service mode determines how this service operates with the system controller. By default
a service is set to start with the operating system. Setting a service to "Start With The
Operating System" (Start With O/S) allows the service to operate automatically, if the system
controller is reset or restarts. Manual control of the service can be set by using the Manual
option for the service mode.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select
the operating mode displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Intercom Type
The Intercom Type selects the intercom that will be connected to the Serial Communications
Interface.
SV001 Intercom
Siedle
Protégé Integrated System Controller Reference Manual
240