PRT CTRL Integrated Controller Reference Manual

Use the [1] and [3] keys to scroll the service types until you reach the Clipsal C-Bus home
automation selection and press [ENTER] to select the C-Bus home automation type displayed
and proceed to the next programmable option for the C-Bus home automation service. For
more information about the list control data entry refer to the section List Control Data Entry
on Page 406.
Service Mode
The service mode determines how this service operates with the system controller. By default
a service is set to start with the operating system. Setting a service to "Start With The
Operating System" (Start With O/S) allows the service to operate automatically, if the system
controller is reset or restarts. Manual control of the service can be set by using the Manual
option for the service mode.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select
the operating mode displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Communications Port Number
The communications interface port defines which serial port the controller will use for
communication with the Clipsal C-Bus PCI Interface. Select the communication port that will
be plugged in to the PCI connection.
SV001 Port
Ext Port 1
Use the [1] and [3] keys to scroll the communication ports and press [ENTER] to select the
operating mode displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
Communications Port Speed
The communications port speed defines the baud rate at which the Clipsal C-Bus service will
operate. The default value for C-Bus is 9600 bits per second. If the speed or configuration is
different adjust this setting to suit the C-Bus PCI configuration.
SV001 Speed
9600
Use the [1] and [3] keys to scroll the communication port speed options and press [ENTER]
to select the speed displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Communications Port Parity
The communications port parity defines the parity configuration for the communication with
the C-Bus PCI. This will default to No Parity however this can be adjusted to suit the C-Bus
PCI configuration.
Protégé Integrated System Controller Reference Manual
238