PRT CTRL Integrated Controller Reference Manual

SV001 Door Grp
None
Use the [1] and [3] keys to scroll the available door groups and press [ENTER] to select the
door group displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
ModBUS Area Control Group
The area control group will define which areas can be controlled by the ModBUS interface if a
area disarm or arm action is requested. The default setting of None allows all areas to be
controlled by the interface.
SV001 Area Grp
None
Use the [1] and [3] keys to scroll the available area groups and press [ENTER] to select the
area group displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
ModBUS Remote Reporting Service
To program the ModBUS remote reporting service ensure that the service that has been
selected is halted. Press the [ENTER] key until the display shows the service type selection
screen.
SV001 Ser Type
ModBUS (Remote)
Use the [1] and [3] keys to scroll the service types until you reach the ModBUS remote
reporting selection and press [ENTER] to select the ModBUS remote reporting type displayed
and proceed to the next programmable option for the ModBUS remote reporting service. For
more information about the list control data entry refer to the section List Control Data Entry
on Page 406.
Clipsal C-Bus Automation
To program the Clipsal C-Bus home automation service ensure that the service that has been
selected is halted. Press the [ENTER] key until the display shows the service type selection
screen.
To operate the Clipsal C-Bus service you must connect a serial communications port using the
PRT-COMM to a C-Bus PCI (Personal Computer Interface) which allows a high level
communication to be transported.
SV001 Ser Type
Clipsal C-Bus
237 Protégé Integrated System Controller Reference Manual