01.07.2014 Views

PRT CTRL Integrated Controller Reference Manual

PRT CTRL Integrated Controller Reference Manual

PRT CTRL Integrated Controller Reference Manual

SHOW MORE
SHOW LESS

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

Enabled the service will use the remote buffer for the look up of register<br />

values. This is used when the Protégé System <strong>Controller</strong> is used to receive<br />

alarms and messages from remote sites that communicate in the Remote<br />

ModBUS protocols.<br />

Disabled the service will use the local objects (Areas, Doors and Zones to<br />

send status and information.<br />

Option 6 – Remote Zone Write<br />

Enabled the service will allow specific coil address’s to interact with the<br />

zones on the system. The zones start on the first zone expander. This<br />

setting allows remote SCADA applications to activate alarms in the Protégé<br />

System <strong>Controller</strong> and report these messages to a standard alarm<br />

monitoring station.<br />

Disabled the coil address’s will operate there designated device.<br />

Option 7 and 8 - Reserved<br />

Reserved.<br />

Reserved.<br />

It is recommended not to enable/disable or modify the settings of reserved options.<br />

Fail To Poll Time<br />

The fail to poll time allows a timer to be triggered on each successful poll from the ModBUS<br />

Master. When this timer expires the Fail To Poll PGM output will also be activated.<br />

SV001 Poll fail<br />

time: 120 secs<br />

To modify the poll fail time (000 to 255, a setting of 000 will result in the default of 120<br />

seconds being used), use the keypad as explained in section Entering Decimal Numbers on<br />

Page 405 and press [ENTER].<br />

Fail To Poll PGM Output<br />

The fail to poll PGM output is activated when the ModBUS service poll fail timer expires and is<br />

deactivated when the ModBUS service completes a valid communication. This PGM setting can<br />

be used to trigger an audible alarm or other indication that ModBUS communication has failed<br />

to operate.<br />

SV001 Poll fail<br />

pgm: --000:00<br />

To modify the poll fail PGM, use the settings as explained in section Entering PGM and PGM<br />

Groups on Page 410.<br />

ModBUS Door Control Group<br />

The door control group will define which doors can be controlled by the ModBUS interface if a<br />

door unlock or lock action is requested. The default setting of None allows all doors to be<br />

controlled by the interface.<br />

Protégé <strong>Integrated</strong> System <strong>Controller</strong> <strong>Reference</strong> <strong>Manual</strong><br />

236

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!