PRT CTRL Integrated Controller Reference Manual

Use the [1] and [3] keys to scroll the communication ports and press [ENTER] to select the
operating mode displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
Communications Port Speed
The communications port speed defines the baud rate at which the DVACS service will
operate. The default value for DVACS is 150 bits per second. If the speed or configuration is
different adjust this setting to suit the host configuration.
SV001 Speed
150
Use the [1] and [3] keys to scroll the communication port speed options and press [ENTER]
to select the speed displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Communications Port Parity
The communications port parity defines the parity configuration for the communication with
the DVACS F1 and F2 subset units. This will default to Even Parity however this can be
adjusted to suit the host configuration.
SV001 Parity
Even Parity
Use the [1] and [3] keys to scroll the communication parity options and press [ENTER] to
select the parity displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
Device Address
When the unit is connected to the DVAC's network it must have a device address
programmed. The device address is typically provided by the monitoring station company.
The address is programmed in Hexadecimal and can not be above 0xF0 hex.
SV001 Device
address: 01
Type the appropriate 2 digit device address, after each digit you must press [] and [] to
move to the next digit. When the desired device address is entered, press [ENTER] to save
the programmed setting and move to the next screen. For more information about
hexadecimal data entry refer to the section Hexadecimal Data Entry on Page 406.
The device address must be configured for a value below 0xF0, failure to configure
the address to an appropriate value will cause the system not to respond.
Events Options
The events options allow you to filter the type of events that this DVAC service will send to
the monitoring station.
229 Protégé Integrated System Controller Reference Manual