PRT CTRL Integrated Controller Reference Manual

SV001 Ser Type
AMX
Use the [1] and [3] keys to scroll the service types until you reach the AMX home automation
selection and press [ENTER] to select the AMX home automation type displayed and proceed
to the next programmable option for the AMX home automation service. For more information
about the list control data entry refer to the section List Control Data Entry on Page 406.
DVAC (Surgard) Reporting Service
To program the DVAC (Surgard) reporting service ensure that the service that has been
selected is halted. Press the [ENTER] key until the display shows the service type selection
screen. The DVAC (Surgard) service is a hard-line polled communication path utilised in North
America across the BELL TELECOM network. A DVAC hardline modem or F1/F2 subset MUST
be connected to the communications port using a DVAC modem cable.
SV001 Ser Type
DVAC (Surgard)
Use the [1] and [3] keys to scroll the service types until you reach the DVAC (Surgard)
reporting selection and press [ENTER] to select the DVAC surgard reporting type displayed
and proceed to the next programmable option for the DVAC surgard reporting service. For
more information about the list control data entry refer to the section List Control Data Entry
on Page 406.
The DVAC F1/F2 subset requires a RX/TX and GND connection; this can be
connected from the terminal block on the communications interface or the DB9
connector. Refer to the communication PRT-COMM installation manual.
Service Mode
The service mode determines how this service operates with the system controller. By default
a service is set to start with the operating system. Setting a service to "Start With The
Operating System" (Start With O/S) allows the service to operate automatically, if the system
controller is reset or restarts the service will automatically restart with the operating system.
Manual control of the service can be set by using the Manual option for the service mode.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select
the operating mode displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Communications Port Number
The communications interface port defines which serial port the controller will use for
communication with the DVACS F1 and F2 subset units. Select the communication port that
will be plugged in to the unit.
SV001 Port
Ext Port 1
Protégé Integrated System Controller Reference Manual
228