PRT CTRL Integrated Controller Reference Manual

Dial Options
The dial options configure the service as to how it is meant to dial when a reportable event
has been generated.
SV001 Dial
[--------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 - Alternate Dialing Configuration
Enabled the dialer will use the alternate dialing method. Refer to the
Alternate Dialing on Page 263.
Disabled the dialer will use sequential dialing method. Refer to the Alternate
Dialing on Page 263.
Option 2 – Dial Number Using Pulse Dialing
Enabled the dialer will use pulse dialing to dial out.
Disabled the dialer will always use DTMF to dial except when Option 3 has
been enabled.
Option 3 - Reserved
Reserved.
Reserved.
Option 4 - Switch To Second Phone Line On Failure
Enabled the dialer will switch the secondary phone line over and use this to
dial if the first phone line fails or fails to communicate.
Disabled the dialer will use the first phone line.
Option 5 - PABX Phone Number Requires Pause
Enabled the dialer will insert a pause of 2.5 seconds after the PABX
telephone number is dialed.
Disabled the dialer will dial the PABX and phone number with a standard
DTMF inter digit delay.
Option 6, 7 and 8 - Reserved
Reserved.
Reserved.
It is recommended not to enable/disable or modify the settings of reserved options.
Events Options
The events options allow you to filter the type of events that this SIA service will send to the
monitoring station.
Protégé Integrated System Controller Reference Manual
222