PRT CTRL Integrated Controller Reference Manual

screen. The SIA service comprises of 3 levels. The transmission of the information uses a line
speed of 300 BAUD and requires a tonal acknowledge.
SV001 Ser Type
SIA (Level 2)
Use the [1] and [3] keys to scroll the service types until you reach the SIA level 2 reporting
selection and press [ENTER] to select the SIA level 2 reporting service type displayed and
proceed to the next programmable option for the SIA level 2 reporting service. For more
information about the list control data entry refer to the section List Control Data Entry on
Page 406.
Service Mode
The service mode determines how this service operates with the system controller. By default
a service is set to start with the operating system. Setting a service to "Start With The
Operating System" (Start With O/S) allows the service to operate automatically, if the system
controller is reset or restarts the service will automatically restart with the operating system.
Manual control of the service can be set by using the Manual option for the service mode.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select
the operating mode displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
SIA Client Code
The SIA client code is used to identify the system to the remote monitoring company when a
report is generated. The client code will accept hexadecimal numbers however this will be
dependent on the ability of the receiver and should be verified before configuration.
SV001 Client
code: 000000
Type the appropriate 6 digit client code, after each digit you must press [] and [] to move
to the next digit. When the desired client code is entered, press [ENTER] to save the
programmed setting and move to the next screen. For more information about hexadecimal
data entry refer to the section Hexadecimal Data Entry on Page 406.
When using a 4 Digit Account code program the account code in the last 4 locations
leaving the first 2 set at 00.
PABX Phone Number
The PABX phone number is dialed to gain an outside line if the system is connected to a
internal phone extension. The PABX phone number can also be programmed with a schedule
in the case that between certain times the phone line is directly connected with an outside
line.
SV001 PABX
None
Protégé Integrated System Controller Reference Manual
220