PRT CTRL Integrated Controller Reference Manual

Use the [1] and [3] keys to scroll the communication port speed options and press [ENTER]
to select the speed displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Communications Port Parity
The communications port parity defines the parity configuration for the communication with
the Protégé System Management Suite. By default this is set to None however can be
adjusted to suit the needs of the host that is connected. When operating the system using the
TCP/IP Interface this setting has no effect.
SV001 Parity
None
Use the [1] and [3] keys to scroll the communication parity options and press [ENTER] to
select the parity displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
Serial Printer Service
To program the serial printer service ensure that the service that has been selected is halted.
Press the [ENTER] key until the display shows the service type selection screen. By default
the serial printer service is programmed at SV004 and is running using the programmed
TCP/IP address and port 10001.
SV001 Ser Type
Serial Printer
Use the [1] and [3] keys to scroll the service types until you reach the serial printer selection
and press [ENTER] to select the serial printer service type displayed and proceed to the next
programmable option for the serial printer service. For more information about the list control
data entry refer to the section List Control Data Entry on Page 406.
Service Mode
The service mode determines how this service operates with the system controller. By default
a service is set to start with the operating system. Setting a service to "Start With The
Operating System" (Start With O/S) allows the service to operate automatically, if the system
controller is reset or restarts the service will automatically restart with the operating system.
Manual control of the service can be set by using the Manual option for the service mode.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select
the operating mode displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Communications Port Number
The communications interface port defines which serial port the controller will use for
communication when sending the serial printer output.
Protégé Integrated System Controller Reference Manual
218