PRT CTRL Integrated Controller Reference Manual

Serial Printer Service
To program the serial printer service ensure that the service that has been selected is halted.
Press the [ENTER] key until the display shows the service type selection screen. By default
the serial printer service is programmed at SV004 and is running using the programmed
TCP/IP address and port 10001.
SV001 Ser Type
Serial Printer
Use the [1] and [3] keys to scroll the service types until you reach the serial printer selection
and press [ENTER] to select the serial printer service type displayed and proceed to the next
programmable option for the serial printer service. For more information about the list control
data entry refer to the section List Control Data Entry on Page 406.
Service Mode
The service mode determines how this service operates with the system controller. By default
a service is set to start with the operating system. Setting a service to "Start With The
Operating System" (Start With O/S) allows the service to operate automatically, if the system
controller is reset or restarts the service will automatically restart with the operating system.
Manual control of the service can be set by using the Manual option for the service mode.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select
the operating mode displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Communications Port Number
The communications interface port defines which communications port the controller will use
for communication when talking with the System Controller. By default the Protégé SMGT
service is started on IP at port number 10000 and is running by default.
SV001 Port
TCP/IP 1 (10000)
Use the [1] and [3] keys to scroll the communication ports and press [ENTER] to select the
operating mode displayed. For more information about the list control data entry refer to the
section List Control Data Entry on Page 406.
Communications Port Speed
The communications port speed defines the baud rate at which the serial communications will
operate. This has no effect when operating in TCP/IP mode. The default value for serial port is
38400 bits per second. If the speed or configuration is different adjust this setting to suit the
host configuration.
SV001 Speed
9600
217 Protégé Integrated System Controller Reference Manual