PRT CTRL Integrated Controller Reference Manual

SV001 Report Opt
[-2------]
To modify options, use the keypad as explained in section Entering Data Options on Page 409.
Option 1 – Enable Event Reporting
Enabled the Service will attempt to send all events back to the Protégé
System Management Suite both when a connection is established and when
it is disconnected. To use this the Server IP and TCP/IP port must also be
programmed.
Disabled events are only uploaded when the Protégé Management Suite is
connected to the System Controller.
Option 2 – Authentication Required
Enabled the Service must login to the server before sending events.
Disabled events are sent with no authentication.
Option 3 – User Login Required
Enabled the authentication will include the pin number of the user stored at
address 0.
Disabled authentication does not use the pin number.
Option 4 – Prioritise Alarm Events
Enabled the service will prioritise alarm events to be sent before all other
event types.
Disabled events will be sent to the server in the order they are created.
Option 5 – Enable Poll Events
Enabled the System Controller will send a poll message to the server at the
programmed interval (see Poll Time below).
Disabled no poll events are created.
Option 6 – Initialize CDMA Modem
Enabled the Service will send an initialization command when the service
starts and then once every 12 hours to make sure the modem is still okay.
This is used when an external CDMA modem is used as the connection
interface (via an external comm port).
Disabled no initialization command is sent.
Option 7 – Backup to Secondary IP
Enabled the service will attempt to send events to the server using the
secondary IP address if communication fails on the primary IP address. No
Protégé Integrated System Controller Reference Manual
214