PRT CTRL Integrated Controller Reference Manual

SV001 Rings to
answer: 008
To modify the rings to answer (000 to 255, a setting of 000 will result in the modem not
answering the line), use the keypad as explained in section Entering Decimal Numbers on
Page 405 and press [ENTER].
PC Phone Number
The PC or remote phone number will be dialed by service when the Call Back Security
Connection option is enabled and a call back event is required or when the automatic event
upload option is enabled. In both cases the PC phone number is dialled sequentially for the
maximum dialling attempts programmed in the service.
SV001 Phone 1
None
Use the [1] and [3] keys to scroll the available phone numbers and press [ENTER] to select
the phone number displayed. To program a phone number select [MENU, 4, 7, 2]. For more
information about the list control data entry refer to the section List Control Data Entry on
Page 406.
Protégé SMGT Service
To program the Protégé SMGT service ensure that the service that has been selected is
halted. Press the [ENTER] key until the display shows the service type selection screen. By
default the Protégé SMGT service is programmed at SV001 and is running using the
programmed TCP/IP address and port 10000.
SV001 Ser Type
Protégé SMGT
Use the [1] and [3] keys to scroll the service types until you reach the Protégé SMGT
selection and press [ENTER] to select the protégé direct service type displayed and proceed
to the next programmable option for the protégé direct service. For more information about
the list control data entry refer to the section List Control Data Entry on Page 406.
Service Mode
The service mode determines how this service operates with the system controller. By default
a service is set to start with the operating system. Setting a service to "Start With The
Operating System" (Start With O/S) allows the service to operate automatically, if the system
controller is reset or restarts the service will automatically restart with the operating system.
Manual control of the service can be set by using the Manual option for the service mode.
SV001 Ser Mode
Start with O/S
Use the [1] and [3] keys to scroll the available operating modes and press [ENTER] to select
the operating mode displayed. For more information about the list control data entry refer to
the section List Control Data Entry on Page 406.
Protégé Integrated System Controller Reference Manual
212