PRT CTRL Integrated Controller Reference Manual

eporting paths that potentially can report the same event to 2 or more locations the report
count should be programmed with an acceptable limit (Between 8 and 16 is recommended).
SV001 Report
count: 000
To modify the report count (000 to 255, a setting of 000 will result in an unlimited number of
reports being able to be sent), use the keypad as explained in section Entering Decimal
Numbers on Page 405 and press [ENTER].
Handshake Time
The handshake time determines the time it takes for the remote receiving unit to answer and
provide a handshake message for the contact ID format. By default this is set to 030 seconds
and should only be adjust if a longer than normal call completion is required.
SV001 Handshake
time: 030
To modify the handshake time (000 to 255, a setting below 010 will result in the default of 30
seconds being programmed), use the keypad as explained in section Entering Decimal
Numbers on Page 405 and press [ENTER].
Redial Time
The redial time determines inter phone number dialling timeout. A value of 20 seconds is
programmed by default meaning each phone number will be dialled with 20 second intervals
from the time the previous call was terminated.
SV001 Redial
time: 020
To modify the redial time (000 to 255, a setting below 010 will result in the default value of
030 being programmed), use the keypad as explained in section Entering Decimal Numbers
on Page 405 and press [ENTER].
Off Hook PGM
The off hook PGM is activated when the service takes the telephone line and is deactivated
when the service completes communication. This PGM setting can be used with remote
exchange systems that require ground start communication connections.
SV001 Off Hook
pgm: --000:00
To modify the off hook PGM, use the settings as explained in section Entering PGM and PGM
Groups on Page 410.
Report OK PGM
The report ok PGM is activated when the service completes the reporting and the messages
have been successfully acknowledge. The PGM is activated when the service returns a
reporting complete result OK message. The PGM is not deactivated and should be
programmed with a timer, this can be connected to an external audible device to signal that
Protégé Integrated System Controller Reference Manual
208